Description

Mustang 910 2008 Parts Catalog

You’ve been burned by aftermarket parts catalogs before. The part number looked right, but the seal you ordered didn’t match the groove. That’s because someone scanned a scanned copy of a scan. The Mustang 910 2008 Parts Catalog is the original factory print – direct from Mustang Manufacturing in Owatonna, MN. 120 pages of part numbers, exploded diagrams, and assembly breakdowns that show you exactly where that O-ring goes.

What’s Inside the Mustang 910 2008 Parts Catalog

Flip to the table of contents on page 4 and you’ll see the manual split into four main sections: Frame and Lift Arm Components, Drive System, Lift Arm Hydraulic System, and Electrical System. Each section gives you an exploded view with callouts tied to a parts list. No guesswork about which bracket goes where – you get the part number and the position.

Drive System Breakdown: Axles, Brakes, and Hydrostatics

From Axle Drive on page 12 through Steering Linkage Hydro End on page 26, every component in the drivetrain is drawn out. Brakes, steering controls, hydraulic motor, hydrostatic unit, gear pump, neutral centering device – all called out with the exact Mustang part number. If you need to rebuild a hydrostatic motor, you want the factory drawing, not a generic sketch. Page 26 shows the steering linkage hydro end split into individual parts – down to the last o-ring.

Hydraulic System Diagrams: Lift and Tilt Circuit Plumbing

The Lift Arm Hydraulic System section covers 24 pages of plumbing diagrams: lift circuit, tilt circuit, auxiliary hydraulics, charge and return plumbing, plus the hydraulic valve and both cylinders. Each circuit has its own page with line routing and fitting part numbers. That means when a hose blows, you can trace the exact routing and order the correct assembly without climbing under the machine with a tape measure.

Electrical System and Wiring

Instrument panel components start on page 52, then fuel tank and rear door hardware on page 56. The wiring diagram is included – not a photocopy, but the original schematic. If you’re chasing an intermittent electrical fault, you need the factory wire colors and connector pinouts. Aftermarket wiring diagrams leave out details that cost hours of diagnostic time.

OEM vs Aftermarket Parts Catalogs: Why Original Matters

The first thing you see inside is “USE ONLY GENUINE MUSTANG REPAIR PARTS.” That’s not just a sticker – it’s a warning. Aftermarket parts catalogs often use generic part numbers that don’t match the actual casting revisions. This manual gives you the part number as it left the factory. For reference, check out Automotive Industry Overview to see why OEM documentation matters across heavy equipment. If you run a fleet, pair this with MUSTANG 940 SKID STEER LOADER PARTS MANUAL and Mustang ME 1503 Compact Excavator Parts Manual. Also see Mustang 2044 2054 2010 Skid-Steer Parts Catalog Factory OEM for later models.

Is this the same as a service manual?

No. This is a parts catalog – diagrams and part numbers only, not repair steps.

What models does this cover?

Mustang 910 skid steer loader, model year 2008.

How do I find a part number for the hydraulic cylinder seal kit?

Flip to the Lift Cylinder page in the Hydraulic Systems section. The exploded view shows each seal and o-ring individually labeled. Match the reference number to the parts list adjacent. Order using Mustang part numbers – avoid aftermarket kits that may use different materials. The manual does not give repair specs, but the part numbers are exact.

Does the catalog include updated part numbers from later revisions?

Revised August 2008. It includes supersessions up to that date. For changes after that, consult your Mustang dealer.

If you maintain a Mustang 910, you need this catalog on your bench – not a PDF that someone’s uncle scanned. For general industry context, Automotive Industry Overview shows why factory specs are critical. Stop wasting money on wrong parts. Access the Factory Manual.