Description

Zoomlion L250-20 Operators Manual

If you’re putting up a tower crane without the factory paperwork, you’re gambling with lives. I’ve seen crews skip the foundation load check because “it looked level.” That’s how cranes tip. This Zoomlion L250-20 Operators Manual is the original factory PDF – 316 pages of the exact procedures Zoomlion wrote for this model. No third-party condensation. No guesswork.

Tower Erection Steps: 5.5.1 Through 5.5.18

Section 5.5 alone is 18 sub-sections. It walks you from installing mast sections (with bolt torque callouts) through the counter-jib assembly, A-frame, jib, luffing rope, and the trial operation. The manual tells you the weight of each component – you don’t pick the wrong crane for the lift. Need the torque for the M24 bolts on the slewing ring? [DATA NEEDED] page reference.

Does This Manual Cover the Foundation Loads?

Yes, and it gives you the raw numbers. Section 4.2.1 lists the load on foundation for crane with outrigger. Section 4.2.2 shows how to dimension the concrete and install embedded anchors. I’ve seen guys pour a pad by eye – that’s a lawsuit waiting to happen. The manual includes the earthing requirement too (4.2.4).

3 Critical Safety Signs Every Operator Must Know

The manual reproduces every security sign from the machine. Section 1 starts with them, and section 5.2 repeats them in the erection context. There’s a sign for maximum wind speed, another for the forbidden zones under the jib. If you’ve never run a L250-20, read those pages first. One oversight on a climb frame latch can drop the mast.

Get the Right Load Capacity Data from Section 2.3

Section 2.3 covers radius and load capacity. That’s the chart every operator uses to keep from overloading. The manual also gives the parked position of the jib (2.2) so you know how much swing clearance you need during transport. Don’t rely on a decal that’s sun-bleached – use the factory chart.

Counter Ballast Configuration – Page References for Different Jib Lengths

Section 4.3 details the counter ballast configuration for each jib length. You get the weight and number of blocks. The manual even tells you how to manufacture the ballast if you’re casting your own (4.3.2). Skip that step and the crane’s tail weight is wrong – the load chart becomes a guess.

Does the manual include torque specifications for the mast section bolts?

Yes, Section 5.5.2.3 lists the tightening torque for each bolt grade.

Can I use this manual for a different Zoomlion crane model?

No, this manual is specific to the L250-20. Even though Zoomlion cranes share some components, the load charts, counterweight configurations, and erection sequences are unique to this model. Using a manual for a L250-16, for example, could result in incorrect ballast placement, leading to tipping. Always match the exact model and serial number. The 316-page manual covers only the L250-20 with its specific jib lengths and foundation loads. Cross-referencing other models is dangerous.

I’ve been turning wrenches since before torque wrenches had digital displays. This manual has the same weight as a factory service book for a diesel engine – every spec is locked to the machine. If you’re working on a Zoomlion L250-20, stop using photocopies from another job site. Access the Factory Manual and keep it in the cab.

• Zoomlion QY30V532.4T/20Y Operators Manual – 276 Pages of Factory Specs
• Zoomlion ZCC1100H 2014 Operators Manual – Crawler Crane Lifting Charts
• Zoomlion RT75 2013 Operators Manual – OEM Factory Specs for Rough Terrain Crane
• Manual Transmission – the crane’s travel gearbox is covered in section 2.5, but the theory applies.
• Manual Transmission – review the basics if you’re new to mechanical drives.